Prepare the skin by thoroughly cleansing with bT-Ceuticals™ CLEANSE. Rinse and repeat. Use Tone to remove any remaining Cleanse from the skin, and blot dry utilizing a facial tissue to remove all remaining moisture. Repeat this process until the surface of the skin is completely dry.

 

Use the bt-analyze™ in 5 areas of the face and neck; 1-forehead, 2-crows feet, 3-below the cheek bone, 4-chin and 5-neck. Document the readings on the facial chart for both sides of the face, and observe the level of hydration compared to the last measurement. Note that different areas of the face and neck are in need of different products with regards to home care prescriptions. Educate the client of their hydration needs during the measurement process. When finished, lightly wipe the membrane of the bt-analyze™ with alcohol. Use the bt-view™ to confirm your moisture assessment with 200x magnification.

Apply a generous layer of Exfoliate to the face and neck. Using upward circular movements massage gently, covering each area at least twice. Re-apply exfoliate and lightly spread over the neck and face. Add a splash of water to allow a fluent application.

 

Utilizing the bt-micro™, press the POWER BUTTON once and then immediately press Mode A – Peel. Press Mode A again and the light will change from blue to red, signifying that you are in the High Option (blue being low). Place one hand on the client’s skin at all times, generally in the area where the bt-micro™ is in contact with the skin, assisting in holding the skin taught. Using the bt-micro™ at a 45 degree angle, use upward strokes covering all areas of the face and neck. During this application, the buttons of the bt-micro™ will be facing the Technologist. You will find the need to remove exfoliated debris from the bt-micro™ periodically. You may also find the need to re-wet the skin should your speed of application not be rapid enough. Your total time for peeling should not exceed 4-6 minutes.

 

Remove the excess EXFOLIATE with water and a warm towel. Use TONE to remove any residue.

 

Apply bt-Cocktail™ Energy 1 to the entire face and neck. Repeat application in the eye area. Set the bt-micro™ to the appropriate setting; Mode C + Ionization, Option High. Using the back side of the bt-micro™ applicator, ionize as well as ultrasound bt-Cocktail™ Energy 1 expeditiously. Energy 1 is very concentrated and will penetrate rapidly. You will have 1.5 to 2 minutes of emoliency to work with. Spend any extra time in the eye area. Remember to always keep one hand in contact with the client.

 

Apply bt-Cocktail™ Energy 2 to the entire face and neck generously. Ionize as well as utilize ultrasound with the bt-micro™; Mode C + Ionization, Option High.

 

Apply bt-Cocktail™ Energy 3 to the entire face and neck generously. Ionize as well as utilize ultrasound by setting the bt-micro™ to Mode B Massage, Option High.

 

Finish with a generous application of RESTORE to the entire surface of the skin; finish with SHADE.